Interested to Buy Any Domain ? << Click Here >> for more details...
We have 420volts, Diesel gen-sets each 750kva 4nos. we are
operating with bus bar duct having 10x150mm for each face
4nos. our question is what is the minimum gap required
between each face? is there any satutory regulations?
- 1 Answers
- 3605 Views
- Alliance One, I also Faced
- E-Mail Answers
Answer Posted / prakash
For Pahse to Phase - 30 to 50 mm
And For Phase to Neutral - 20 to 25 mm
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Whether power factor should be high or low? Why?
Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter
For an induction motor wat is the loading/unloading cycle duration or interms of L/UL ratio/ percentage?
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
pls tell me about ups internal connection & we have given only 3 phase supply to ups system how get 4 wire (R Y B N )
how meger function
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
A motor running with lenze frequiency inverter stops if I REDUCE SPEED with 25% load.If I run it in High speed and medium speed running smoothly with full load.please help me to solve it.
what is cathodic protection and why it use in industries?
what is value of Jin transformer
In CTs tan delta point should be earthed , what is the reason behind it?
why ct ,cvt should be stored in a vertical position?
why single CT used in DOL starter power circuit?
what is the meaning of 5% droop or 7% droop in AVR?
