Answer Posted / rushi913@gmail.com
IF their is permanet capaacitor are used for as an fan
motor then it must use the capcitor their is need to
increse the starting torque of the motor to running the fan
as we need.Also to used as fiter in ckt.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
how does it help for selection of a transformer.
what is the difference between oil surge relay and buchholz relay.
How to calculate Number of Earthing Pits....???
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
witch pump used in wtp
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
Name of the relay of low lub oil presuure in DG sets
What is q factor?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
what is transient enclosure vltage , very fast transients, very fast transient over voltages
