Answer Posted / keyur

main application of sink and source is to control of direct current flow in load.
DIfference b/w sink and source is
SINK MODE provide a path to 0V DC (-DC)
SOURCE MODE provide a path to +24V DC (+DC)

we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.

1289

---

defination of radial vibration?

1684

---

I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .

1564

---

What is the reason PT speed not incresed in gas turbine?

1926

---

flow transmitter formula?

2370

---

---

please send data bank of quetions answers on analytical instrumentation.

1471

---

Please tell me details about Sox,Nox,SWAS analyser????

3295

---

There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?

1474

---

How to convert Differential pressure to flow in TPH

1765

---

can anyone tell me about the basic concepts to consider before to start a PLC panel wiring

1517

---

what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?

1228

---

Why mixer nd grinder Is example of constant torque load not variable torque load ???

1504

---

how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.

578

---

what is gas metering system? gas chromatograph? and gas compressors?

1974

---

How can you add value to this Industry if offered the job?

1175

---