Interested to Buy Any Domain ? << Click Here >> for more details...
Why cant we connect the motor output to generator and then
generator output to motor ?
- 4 Answers
- 7471 Views
- I also Faced
- E-Mail Answers
Answer Posted / atif
we can't do this practically b-coz Motor starting current
is more than running & generator initial voltages are not
enough to start the motor thats why they can not start
directly. In running condition there is fluctuation in
generator posible to stop motor if we start motor using a
second as primover. So it is difficult.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is the size of ht cable of 33kv ht line and transformers ratings are 1 Mva and 5mva.please send formula also.
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
What is core CT & it's function?
State the formula for overall efficiency of thermal power station
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
what is stper motor
how many load we can take for lighting
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
What is the efficiency during maximum power transfer?
How many size of cable required for a 300m long and 30kw inductive lode
what about SAP/MRP regarding manufacturing of electric motors and all drives?
What do you mean by cogeneration? What its working principle?
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
What happens if i apply 500V to 440V rotary Switch ?
