Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference b/w tube and pipe ?
- 6 Answers
- 11487 Views
- BSL, Descon, Kirloskar, I also Faced
- E-Mail Answers
Answer Posted / rameez_rz2000
we take the inner dia of tube and outer dia of pipe because
of paints or isolation on it
| Is This Answer Correct ? | 13 Yes | 5 No |
Post New Answer View All Answers
State some of balance principle’ advantages?
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
How does your previous experience relate to the job you are applying for ?
field bus transmitter calibration procedure tell me
Please asked me How calculate DCS controller memory.
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
Operational amplifiers
How to change dcs card in online. (Dsc is maxdna)
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
What are different types of cable?
what is the process for double acting cylinder pneumatic for 32' v/v
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
