Interested to Buy Any Domain ? << Click Here >> for more details...
Hello Can I use step up HV transformer 440/4160V as a step
down? Thanks
Evgeny
- 5 Answers
- 7779 Views
- I also Faced
- E-Mail Answers
Answer Posted / abdul
Thikness of conducter is not an issue here. current flows
only when connect a load at low voltage side. Current will
be still very less at 4160 side.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
how to calculate the no load current in transformer?
why the India electrical supply transmission loss is high when compare to us
Define end float in a motor?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
hwat type of motor is used in thermal gas turbine hydro nuclear power plants and why
What are the main advantages of bode plot?
What is the abbreviation of NGT panel
why we r not earthed Control cable of C.T. terminals
What is a commutator?
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
at work i have a genertor/alternater what is the easyest way to work out if it is dc or ac?
Explain about retrofitting of machine tool.
what is a vector protection in transformer
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
how i calculate the syncrones generator NGR resistance .if we have a 6mw generator line voltage of generator 11kv also line current 393.3 ampere.
