Interested to Buy Any Domain ? << Click Here >> for more details...
why we use delta connection in primary and star connection
in an distribution transformer,which converts 400V a.c
voltage to 33KV?
- 2 Answers
- 5420 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramesh patel
Hi,
1. The distribution transformer is meant for 3phase 4wire
system and is for utilities where the fourth wire i.e
neutral is required by users for protection and control of
the switch-gears and power network.
2. Primary delta and secondary star connection prevent the
source side harmonics to impact the secondary side utilities.
3.No need to carry neutral wire of the 400VAC system to the
transformer, if primary is delta connected bcz only three
wire solve the purpose in delta /Star and neutral wire
easily connected to star point of secondary.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is Air Turbulence?
what/why did you choose your college major?
While flying, what you should do in an emergency?
What would you do if your captain were not following the instructions properly?
Rotation of dc shunt motor is revers by using 2 methods, which method is best and why?
what do you mean by stalling of aircraft?
what can passengers do to ensure safety?
Why Pilot hits ground hard during bad weather?
what happen when diesel genset supply connect to main supply
What are the laws of gyro-dynamics?
How would you handle the extreme pressure during emergency situation if you know that plane is not safe and it might crash anytime?
What is Jet Lag?
What is SPICE? Where was it developed?
1.What is IDT? 2.What is permanent shear buckling? 3.Explain Crippling? 4.Why IRB check is imp while one design fuselage? 5.Explain Column buckling?
Explain what are the main areas in aviation?
