we want low electricity at lower speed of fan.what we have
to do?
- 5 Answers
- 5181 Views
- I also Faced
- E-Mail Answers
Answer Posted / praadeep_dd@yahoo.com
If we want low electricity to lower speed of fan we put a
regulator.(Insert resistance in series.)
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES
RESPECCTED SIR/MADAM- I AM PRERING FOR SECTION ENGINEER (ELECTRICAL) RRB CHANDIGARH PLEASE SEND ME SOME PREVIOUS YEAR QUESTION PAPER OR MODEL PAPER.MY EXAM IS ON (30- NOVEMBER 2008).I AM VERY THANKFUL TO YOU. FROM- HARENDRA SINGH YADAV
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
What is a system?
why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?
how to calculate cable size in diffrent loads?
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
What is a diode?
Why is ignitor used in sodium vapour lamp
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
How much costly in percentage wise is sandwich busduct costly than air insulated busduct of any rating?
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
What will be the diameter of pipe between conservation tank and transformer
what is the IPC ? & what the uses ?
