Interested to Buy Any Domain ? << Click Here >> for more details...
how we protect the motor & what are the components required
for that ?
- 2 Answers
- 5074 Views
- I also Faced
- E-Mail Answers
Answer Posted / kalolia alap r
depend on the kind of current,i.e both a.c and d.c required
protection.. motor required starters,like basic D.O.L etc.
in small motor we do not required armature resistance but in
large size of motor,we required large armature
resistance..basicaly required component is resistence in
megaohms and some times induction regulator like auto
transformers....
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why the pf of semiconductor device is improved the electrical devices
what is the principle of operation of CFL ??
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
Why there are some equipment(i.e:TV) that using 2-pin plug instead of three? What happen if there is current leakage? Are we going to get electric shock??
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
What is the application of Dyn1 and Dyn11 vector group of transformer?
difference between the applicability of nortons and thevenin theorem
What is dc current source?
Describe Non I.S. Earth System and why is it used?
what is meant by 3rd hormonics ?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
Define de-sensitivity?
how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
