Interested to Buy Any Domain ? << Click Here >> for more details...
How to explian the V model. Diagram not required but iwant the
answer gnerally
No Diagram explanation plzzzzzzzzzz..
- 2 Answers
- 12446 Views
- Accenture, TCS, I also Faced
- E-Mail Answers
Answer Posted / ramyasri
Hai...
Conventional V-Model represents the development process in
the form of a V shape. The right side of the V represents
the testing where the systems is validated against the
specifications defined on the left side. The meeting point
of the V represents the actual development
Business Requirements Acceptance Testing
\ /
SRS SYSTEM TESTING
\ /
HLD INTEGRATION TESTING
\ /
LLD UNIT TESTING
\ /
CODING
The V-model is a graphical representation of the systems
development lifecycle. The V-model is a software
development process which can be presumed to be the
extension of the waterfall model. Instead of moving down in
a linear way, the process steps are bent upwards after the
coding phase, to form the typical V shape. The V-Model
demonstrates the relationships between each phase of the
development life cycle and its associated phase of testing.
The four main process phases – requirements, specification,
design and implementation – have a corresponding
verification and validation testing phase.Implementation of
modules is tested by unit testing, system design is tested
by integration testing, system specifications are tested by
system testing and finally acceptance testing verifies the
requirements.
The V-model gets its name from the timing of the phases.
Starting from the requirements, the system is developed one
phase at a time until the lowest phase, the implementation
phase, is finished. At this stage testing begins, starting
from unit testing and moving up one test level at a time
until the acceptance testing phase is completed.
Thanks & Regards
B.Ramyasri
| Is This Answer Correct ? | 8 Yes | 4 No |
Post New Answer View All Answers
Hi, Can anyone suggest a test case writing technique for the below scenario. 1. User draws a lines on the image 2. User selects the lines and right clicks ( Measuremnts like distance between the start and the end point, coordinates of start point and coordinates of end point) 3. User selects one of the measurement Measurement is displayed Just want to highlight, i am looking for a test case writing technique for above scenario.
what is the cheklist to check SRS document (after releasing) as a test ingineer and how can we check
write the test senario on opening door in the flow diagram format
What type of metrics would you use?
I have 2 years of exp. in testing and looking for a change if any body knows, about any vacancy in testing then plz contact me on deepti_ac@yahoo.co.in
What is alpha testing?
What is software configuration management?
What are the queries mostly asked in testing ? give me some examples.
Give me an example of something you tried at work but did not work out so you had to go at things another way.
What are the factors affecting a manual testing project and what are the ways to overcome it?
give me a example of writing a test case,take any good example which i can understand easily.
Differentiate verification and validation?
what the purpose of requirement phase
Can u give me explanation about section 508 testcase and Testcase for this section. It need a details checklist for the same Manimozhi
Zenq interview questions for manual testing
