Interested to Buy Any Domain ? << Click Here >> for more details...
why we generate transmit and distribute electrical supply
in multiple of 11
- 6 Answers
- 11904 Views
- NHPC, I also Faced
- E-Mail Answers
Answer Posted / shelja singh
becoz as power is transmitted, losses does occur. so we are
providing a margine of 10% to account for this drop. i.e. if
the transmitted power is 110 units then we are receving 100
units at least.if the drop is more we are to take corrective
methods.but if the losses are well in this 10% range nothing
to worry.
| Is This Answer Correct ? | 2 Yes | 10 No |
Post New Answer View All Answers
what is meant by motor startup supervision & motor load jam protection ?
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
How to calculate the sag of OPGW during stringing???
What is I to C?
How many capacitors using in LT panel as per Govt rules?
What is the purpose of stablization resistor in high impedance bus bar protection
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?
In Generator How suction compression power and exhaust works ?
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
What are the different types of hydro schemes?
what is metering cum synchronizing panel and how it is used?
