Interested to Buy Any Domain ? << Click Here >> for more details...
For an Instrumentation Engineer, is there any effect on
Instruments of safety zones like zone0, zone1, zone2.
As an instrumentation Engineer, what we have to consider or
remember while working in these areas.( zones 0,1,2).
- 1 Answers
- 4543 Views
- I also Faced
- E-Mail Answers
Answer Posted / mpf
You probably mean on explosion hazard zones. Most of
instrumentation equipment falls in the category of intrinsic
safety ("i") and therefore can be placed in all zones (with
some limitations to zone 0) being zone 0 the most strict zone
where exploding substance is always present and zone 2 - the
least strict zone where the potentialy exploding substance
could be present in short periods of time in case of an
failure. Otherwise, if the equipment is not of "i" type of
protection, other rules apply.
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
How do you identify an orifice in the pipeline?
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
WHAT IS THE DIFF. BETWEEN SKIN TEMPERATURE AND PASSES TEMPERATURE..?
What is difference between Ionization heat and bimetallic heat
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
where cascade loop use ?
If we increase only P what will be controller action ?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
Speedtronic system .
what is metal of piston ring
what is cems analyzer explain with principle and drawing ?
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
