how to load a software in server
Answer Posted / nikhil pagnis
1)Initially to load the Software u need 2 hve admin rights
w/o which it is just not possible.
2)Only the Administrators and the users (to whom the
administrative rights r given can load the s/w) ----
considering the fact that almost 80% of the softwares
require Administrative previliges.
3)As Surya had suggested i would like to make a small
correction (although i wouldn't say that Surya has given a
wrong answer)here----One can make use of the CDROM or the
s/w can be copied onto the Hard Disk (again depends on the
rights and privileges).
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What are rights networking?
What is firewalls?
Port modes [trunk and access] have any influence on VLAN tagging and un-tagging?
Give some drawbacks of implementing a ring topology?
one server is down it doen't display anything what you do?
Define one basic requirement for establishing vlans?
Define ipv6?
Explain how are ip addresses arranged and displayed?
how to set tunneling in putty when any portno blocked from firewall to use resources with that portno like ssh 22
Define tunnel mode?
Define rip?
Can you please explain the difference between hub and a switch?
Tell me what happens when you use cables longer than the prescribed length?
Give the importance of the osi physical layer?
Explain the importance of encryption on a network?