Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / osahon
Ambient temperature is simply the prevailing temperature of
your surrounding
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
SOME OF YOUR QUESTIONS ARE NOT MAKING ANY SENSE SO TRY AND PUT IN A LITTLE BIT MORE EFFORT BEFORE YOU POST A QUESTION. WE WILL ONLY HELP THOSE WHO WE CAN SEE ARE TRYING TO HELP THEMSELVES.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
What is the use of GMV in turbine?
what is the minimum power (P=VI)to produce a spark?
what is 24vdc live and dry supply
Explain types of valves?
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
With N nodes and B branches what will have a network ???
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
How to measure the dust in chimney(spm)?
What is the differerence between hysterisis and linearity.
What is Predictive Maintenance
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
