Interested to Buy Any Domain ? << Click Here >> for more details...
what is the frequency standard with tolerance level for India?
- 16 Answers
- 27578 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh kumar singh
50 cycle/second and tolrence +,
-3%
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
In vapour absorption refrigeration machine fluids used are
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
i have applied for junior engineer 2 c&w for Guwahati RRB please send me last five year question paper
why servomotor motor? where i apply for best output?
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
I Have 3 Phase 10 KW AC Alternator i found one phase weak, so what will be the reason & what action shouls i take to rectify the same.
What is referred to the electron in the outer orbit?
how to put cable sizing and cable glands size for respective cable & Cable Lug size in a DB sectors???
Why the efficiency of generator is more than motor in swinburne's test
why most of junction box vendors providing T5/T6 Temp class jb's for T3 area any special reason?
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
How would you relate your key competencies to this position?
how technical is calculated in 11kv line and lt line
