Answer Posted / rajesh kumar
amplitude of an ac voltage continiously with time
it has a frequency
dc voltage does not have frequency
the amplitude does not vary with time
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
why using negative supply for bentley nevada vibration system ?
whatis range of marcury filled tempereture gague
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
Why even multiple power supplu r used in instrumentation system?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
With N nodes and B branches what will have a network ???
where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,
Linear amplifier.
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
