how does electrical train works and what type of motors are
used to drive the train?
which level of supply voltage is used?
- 22 Answers
- 59364 Views
- Alstom, Infotech, I also Faced
- E-Mail Answers
Answer Posted / ranjan
Train uses the d.c series motor.An electric train recive
25*1000v from the overhead lines which voltage rectifi(step
down) by the transformer to 600 a.c voltages which further
convert to d.c voltage bcoz d.c series motor for starting
torque high.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
if any house we instaled a 1.5 ton ac and its phase cable of wiring is installed but netrual cable of wiring not instaed. my question is that is neutual of house(for other wiring is capable for ac load or a sepeart neutrual wiring required
If any cable burnt how can we identify it burnt by high current of high voltage?
what is cause of static electricity? I experience shock when i touch metal equipment in a room ,furher check shows earth leakage showing 80ma at the DB near to the 400 MCCB?
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
What is mason's gain formula?
WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
what is the effect of higher value of GD???
Any one who apply for Ferro Scrap Nigam Limited cn join with me at rajuhalder@indiatimes.com or 09669717028
If UG power cable both ends are to be earthed or what? If not why?
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
Give some example of fault limiting devices?
How to calculate Ith (I thermal) for curent transformer
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
