Interested to Buy Any Domain ? << Click Here >> for more details...
hi
i am facing one problem.ptoblem is like that i am getting
output error on mine router ethernet interfae
here is the cisco#show interface e0
Ethernet0 is up, line protocol is up
Hardware is QUICC Ethernet, address is 0030.802d.2a17
(bia 0030.802d.2a17)
Internet address is 202.122.20.225/28
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely
255/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive set (10
sec)
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 05:55:07
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 10000 bits/sec, 11 packets/sec
5 minute output rate 29000 bits/sec, 11 packets/sec
1515202 packets input, 359100396 bytes, 1 no buffer
Received 6 broadcasts, 0 runts, 0 giants, 1 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored,
0 abort
0 input packets with dribble condition detected
1584394 packets output, 1623395338 bytes, 0 underruns
1820 output errors, 26732 collisions, 0 interface
resets
0 babbles, 0 late collision, 9698 deferred
18 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
output
cisco#
what is the reason
how to solve this
please tell me
i am using cisco asa 5520 behid mine internet router
and no error on the asa inside interface
- 2 Answers
- 5272 Views
- I also Faced
- E-Mail Answers
Answer Posted / dharmendra kumar soni
Hi jit,
I think ........
1> Loop exits in the circuits friest you contact your leased
line provider.
2> Owner of remote router to remove loop.
Bcz your router creating loop. And your interface is
functioning properly.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What route entry will be assigned to dead or invalid route in case of RIP?
What is name of ospf algo?
What is formula of hold down time of eigrp protocol?
Define logical topology.
What are the advantages of using switches?
Explain what is overlaod?
What is the difference between the communication and transmission?
What are the netbios and netbeui?
What are the different ways authentication mechanism in VPN?
What is loop back ip in ipv6?
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router router?
Is hub intelligent device?
On which mode we give debug command?
Does a bridge divide a network into smaller segments?
How do we do encryption and authentication in L2F?
