Interested to Buy Any Domain ? << Click Here >> for more details...
When a square wave is applied to primary of a transformer
then what will be output wave form of secondary ?
- 2 Answers
- 6439 Views
- Sail, TCS, I also Faced
- E-Mail Answers
Answer Posted / vikram
THIS IS CALLED PULSE TRANSFORMER.
IF INDUCTANCE IS HIGH THEN OUTPUT IS EQUAL TO INPUT.
IF L=LOW IT PRODUCES EXPONENTIALYY DECAY PULSES
IN BOTH +VE AND -VE CYCLES.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is the selection process of breakers. Can any one please give a formulation on same?
Explain marx circuit.
reason of diode failure in alternator
PLZ SEND ME SOME UNIQUE PROJECT OF ELECTRICAL ENG (B.TECH)
what is the working principle of a DG Set, Alternator, & exiter
how to revers the direction of single phase motor
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
Why is tan-delta test and capacitor measurement done on alternator?
can the measured percentage error during calibration of single phase energy meter be negative?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
what things to be considered when designing UPS
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
