Answer Posted / mangesh
In gerator syncronisation there are follwoing three steps.
we will call machine to be syncronised as incoming machine
(1) same voltage
(2) same frequency
(3) same phase angle
Scoboscope is used for syancro. also there are another
method named 2bright 1 dark and vice vrsa.
The power angle delta between induced emf and terminal
voltage determines the power transfer.
| Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
HOW TO CALCULATE HV CABLE SIZING?
how slip power recovery system work
What are the conditions to be satisfied for parallel operation of dc generators?
Explain the role of a car driver as one of a feedback mechanism.
2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
why ten delta testing is carried out on power transformer
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?
pls tell me function of closing coil of A.C.B.
how to calculation increase capacitor,increase power factor for three phase.
how to find out 3 phase complex power in per unit in unbalanced system?
What is the restart inhabit setting in ABB spam150c relay (Motor protection relay)
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
What Maximam Gap Taibaar & Bush
what is meant by moulded case circuit breaker ?
