Answer Posted / mohammad reyaz ansari
Globe valve, Butterfly valve, Gate valve, Diaphergm valve,
Ball valve, Knife Edge valve, Angle valve, Three way valve,
Twoway valve.
| Is This Answer Correct ? | 43 Yes | 8 No |
Post New Answer View All Answers
Specify ideal accuracy of flow element like orifice plate, Ventury, Annubar. Ultrasonic flow meter etc.
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
how to calibrate corollaries (Mass flow meter)?
what is difference between HOT permit and cold permit
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
How to Calibrate Interface Level Troll in field
Explain how thw analog to digital converter works with the circuit diagram
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Draw block digram for well head from well to shipping pump?
What are the materials available to prepare individually for competetive exams in Instrumentation field? Plz reply...
selection of the zener barrier for the hazardeous area zone 0
With N nodes and B branches what will have a network ???
what is gas metering system? gas chromatograph? and gas compressors?