Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raghavendran.r
Distance protection relays work on the value of Z = V/I.
Whenever there is a fault, the value of I increases and
thus the value of Z is reduced.It is by this vakue of
impedance the relay senses the distance of the fault from
its location.
It is also called as Ohmic method of Protection.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
What is reactive power and where it is used.
Why reactive power is needed in a power system? How is it being absorbed or delivered by alternators? For reactive power control we are changing excitation but reactive power absorbing or delivering related to stator. How these two are interlinked? i want a detailed explanation with necessary expressions and figures?
what are the factors to be considered while design the breaker either HT or LT??
How many types of oil using in H/T & L/T Oil Circuit Breakers. need Explenation ?
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
what are safety measures in /control in diesal engine/ explain them?
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
Which test will be more severe for VCB?
what is an unbalance in acircuit? in a three phase 3wire circuit how an unbalance will come? in a three phase four wire system how an un balance is coming?
what is the use of static frequency converter and static excitation equipment? and where it is employed? for what?
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
