Who is reputed manufacturer of TNC switch for ACB in India ?
- 3 Answers
- 5895 Views
- I also Faced
- E-Mail Answers
Answer Posted / shanthkumar
i think larsen and toubro(L & T)
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
Why the efficiency of generator is more than motor in swinburne's test
What is the unit of magnetic flux density?
diff b/w elcb and rccb
Why sometime AVR and sometime Booster coil is used in Alternator? what is the diferance between AVR & Booster coil due to which they are selected
How stabilizer works??
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
how many electricity poles are there and what are the names and their sizes.
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
Explain thin film resistors and wire-wound resistors
explain supply side and demand side energy management with advantages & disadvantages
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
what is parellel power factor correction?
