Interested to Buy Any Domain ? << Click Here >> for more details...
THE ROTIO OF VOLTAGE AND CURRENT IN A CLOSED CIRCUIT
- 12 Answers
- 29149 Views
- APGenco, Constant, Lanco, I also Faced
- E-Mail Answers
Answer Posted / anusha
the ratio of voltage and current in a closed circuit gives
the equivalent impedance of that circuit and it may vary
depending on the frequency of the supply voltage.
| Is This Answer Correct ? | 8 Yes | 4 No |
Post New Answer View All Answers
Why delta star trformers are used for lighting loads?
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
how does commutator convert a.c to d.c?
how is the incoming cable size calculated for a given current rating of a panel??
1.what is difference between ATS & STS main use. 2.what is difference between ACB& VCB With symobles,and main partes, manimum range. 3.How many types of relays and main function.
lenz law application and define
What is tranformer differtial?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
given data are load current & power factor cable core size? plz any one update the calculation formula
WHY IN AC DRIVES,INPUT PHASE CURRENT SHOW UNBALANCE?
how mass curve differs from hydrograph.
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
Does the direction of rotation of d.c. Shunt motor would get reversed if the armature current and field current both are reversed?
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
