Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / t.sudhakar
1.TO AVOID THE GROWTH OF PLANTS AND GRASS NEAR THE YARD
BECAUSE THIS WILL CREAT THE SHORT CIRCUIT.
2.THE ANIMALS ARE NOT WALKED OVER THE STONE ALSO TO AVOID
THE SHOCK ACCIDENTS
3. KEEP THE MOISTURE ALWAYS BOTTOM OF THE STONE TO REDUCE
THE EARTH RESISTANCE
| Is This Answer Correct ? | 37 Yes | 10 No |
Post New Answer View All Answers
how does a submersible pump work..?
What is diversity factor in electric installations?
i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.
why a tester wont shock while testing the power in house
The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.
how to meas-our losses for L.T & H.T
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Please send 110 kv sb station full single line drawing(sld)
How to select transmission line type (i.e. 11kv or 33kv) for new established industries
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
l&t switch FN 63 handle position can we change
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
Lt motor sfu flashing reasons?
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
