why transformer rating in kva and motor rating in kw
- 11 Answers
- 15366 Views
- I also Faced
- E-Mail Answers
Answer Posted / zeyad
when we calculation the power of motor : p= v*i *cos&
but when ------------------------ trans : s= v*i = va
at trans total power maen that : s=p+q
wher: s = total power or apparent power
p= active power( this is the force depent in motion
motor )
q= reactive power( depend in sometime losses)
wehre cos&= real power/apparent
finaly all of above are unit of power
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What is meant by a stray loss of a induction motor??? What is the equation to find it
300m long and 30kw inductive loade 3phase supply how many size cable required
please suggest some good universities with low cost iam in totally full confusion so please help me my profile gre 283 and ielts 5.5
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
when elecromagnatic waves are propogated in a wave guide?
HOW THE OLTC TRANSFORMER SAVE ENERGY IN COMPARISON TO OFF LINE TRANSFORMER AND IS IT ECONOMICAL TO REPLACE THE OFF LINE TRANSFORMER TO OLTC TRANSFORMER
how can i apilly for electrical c licencese.sir,i completed B.Tech in electrical & electronics engineering in 201onot working any company
in shunt clippers why a resistor is used in sereis with the input
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
What is the differentional relay...what is the work of this in power Tx. how it is works..
What is the IS standard for MCCB to be use (As per capacity of AMP)& for ACB also.
How each of the following losses occur in d.c machines (i) copper (2)core (3) windage (4)friction please help me
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
