what is the generation action and motoring action?
- 3 Answers
- 12144 Views
- I also Faced
- E-Mail Answers
Answer Posted / anu
in generating action current flows in the direction of induced emf whereas in motring action the direction of curren and induced emf are opposite
| Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
how can tell us the AC indoor or outdoor which Tr and formulls
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
What is sink and source?
what is the role and fuction of automatic transfer switch in rotary ups
How to measure the earth resistance value in a concrete pavement(flood light area)?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
what is the purpose of shading ring or shading coil in electrical equipments.
what is the voltage regulation for unity and zero power factor?
what types of cable used in underground coal mining?
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
can we conduct the swineburne's test on a dc series motor? why?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
