why inductance is not present in a incandescnt lamp?
- 2 Answers
- 3864 Views
- I also Faced
- E-Mail Answers
Answer Posted / vijin
tungsten is highly resistive and low reactance metal. even
if it is curled the rssistance will dominate the reactance.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Why back emf used for a dc motor? Highlight its significance.
A power transformer 4MVA/11KV/0.415Kv has been out of use in 12years. what maintenance actions/test need to be carried out before energizing.
What is the reason for using a GE G101 MCB in place of an EP102 MCB if both are capable of AC circuit protection?
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
why we are using Load factor?
why we need to us lenz's law for synchornous motor
what is cogging and crawling
how many current required for hypo test
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
what is level 2 automation?
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
please send me RRB electrical engineer previous year questions for Sr. Section Engineer
