Interested to Buy Any Domain ? << Click Here >> for more details...
why most of the induction motors are delta connected?
- 7 Answers
- 27941 Views
- I also Faced
- E-Mail Answers
Answer Posted / bob
because the motor power in delta connection more than star connection three times
so if your power source can start up the motor in delta connection (current bigger 3 times of star connection ) you do not have problem.
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
what type of earthing do for dry fissure rock?
what is effect of length of air gap on performance of dc motor and generator?
what is level 2 automation?
When and where resistance earthing is used ? How to calculate the time constant for earth fault
I want to know all basics of electrical engineering
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
how open delta PT works & what is its construction?
can anyone explain 11kV 3core cable megger,hi pot test procedure with connection details?
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
What happen when neutral point connected to core balance current transformer? (Neutral point of an alternator of a 180KVA DG. Neutral point connected to CBCT means enter to the CBCT)
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
which type of motor is used in automatic swing gate
we have provided 30 nos. relay contacts in panel.I want to know how do we do the numbering for the relay contacts as per any applicable standards
Explain thin film resistors and wire-wound resistors
how to select electrical equipment such as fuse,dg,transformer,motor,msb,wire,cable as per the connecting load..please mention any books to design,take licence
