only three phases are coming in step down tranformers.how
to get neutral?
Answer Posted / sandeep
star point of the transformer has to be grounded to get a neutral point
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is highest size of HT motor like 11 kv or 33 kv,and how to make it 750 rpm.i think the size will be very big.any idea ? pl. reply..
what is the reqirred voltage in HT motor to get full RPM on no load test?
is it possible to have dc motors on single chip
What is FTA card? How it works?
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
what is vA rating and class of a ct.
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
What is the main cause of magnetism?
what is the meaning of WYE and DELTA in Electric meter?
What are differences between Voltage, EMF & Potential difference ?
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
What is the difference between diesel generator engine with and without turbo charger with the same capacity?