Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / aanand
Gears are made of variety of materials depending on the
requirement of the machine. They are made of plastic,
steel, wood, cast iron, aluminum, brass, powdered metal,
magnetic alloys and many others. The gear designer and user
face a myriad of choices. The final selection should be
based upon an understanding of material properties and
application requirements.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
Why should a chain drive be used over a belt or rope driven drive? State pro`s and con`s?
DOES IS 2062 SPECIFIES ONLY SEAMLESS PIPES OR ERW PIPE IS ALSO COVERED UNDER IS 2062
How the bearing numbers are allocated?
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
what is inlet gas pressure of ge 9 fa gas turbine ?
Explain about front drive mechanism in vehicle
What type of job are you holding at the moment? What is your desired employment / occupational field
How much calorific value of heat is needed to heat 00c of
How engine design needs to be changed to burn lean mixture ?
What is an expansion valve and its purpose?
Inspection for intermediate shaft bearing.
How much pressure on air reservoir?
what is the stanton curve?
What is meant by hybrid vehicles?
which material is suitable for punching press to avoid scratches amd waear of metal hittimg the blades?
