What is the difference b/w EMF, voltage & potential
difference?
- 1 Answers
- 4660 Views
- I also Faced
- E-Mail Answers
Answer Posted / aadi
ElectromotiveForce,Voltage, and Potential
Difference...virtually are the same, except that...
EMF is more of an Electrical term,in terms of the force req.
to move a charge from a point to another, ...
Voltage is the Electric Potential of a point w.r.t ground...
...and Potential Difference is the difference in the
Electric potentials of two relative points...(since its
relative, it always has a + or a -!!)
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
the output of the common trasmitter protocol in qatar gas are the following
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
it is possible to check the fail safe condition in pressure transmitter. if possible how?
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
Explain plc level and its type?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
Any one can help me to identified, how can we interchange the device in FF
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
what is exact time to study dcs and plc cources
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
how to calculate range of level transmitter?
what is sliding spool valves?
can you provide me full detail about instrumentation in ONGC??
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
how to calculate the total flow in square root
