Interested to Buy Any Domain ? << Click Here >> for more details...
Please tell me if you are electrical engineer,and you are
appointed for the maintainance of Electrical Power plant,then
which parts of the plant deal with you.Also tell how these
parts/components work.
- 1 Answers
- 3420 Views
- I also Faced
- E-Mail Answers
Answer Posted / satendra
You have to look after the Protective relays in the generator and transformer. At the time of shutdown you have to check each and every part of generator and motors.
And in concern to your second question, this can't be answered in just a few words you have to study four years of engineering.
satendra.svnit@gmail.com
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is earth?
what is the effect of higher value of GD???
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?
How may I enrol or get admission to your program?
how load of a turbo generator can be increased
How to distinguish whether MCB is DC or AC looking at it physically
What is an Air COmpressor
Hello sir, pls send me hpcl technical test papers .i am. Appearing for the exam.
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?
how to select the no. of brushes in a lap winding?
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What is Surge Capacitor? Why it is use in Generator Circuit Breaker?
