Answer Posted / jitendra pawar

We can not identified what is the direction of power flow
in transmission line by after looking the tower because
tower and line from incomer and outgoing both are similar
it's not idendical.

While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?

3580

---

why i can not use thimble on capacitor duty contactor

1399

---

what is star delta starter? how it works? give its control and power diagram.

2137

---

what may the reason for vector shift in a generator?

1919

---

In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?

2035

---

if we install two earth pits with a clear space of 5m without any interconnection,by checking the digital multimeter will it show continuity between earth pits? If so what would be the approx. value

1996

---

I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.

2144

---

Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics

2360

---

dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?

2135

---

WHAT IS counter flux IN CT?

1999

---

How does the phase sequence controller works, how it identifies the phases? confirm working principle

2162

---

If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)

2014

---

can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?

1499

---

What do you mean by passive circuit elements and why these are called passive?

1257

---

How is the connection of the tap changer on the HV side been made?

2037

---