Interested to Buy Any Domain ? << Click Here >> for more details...
what s the differenc between electrical &electronis , how
to define them
- 9 Answers
- 11246 Views
- I also Faced
- E-Mail Answers
Answer Posted / farhan sohail
electrical:
those components which dont required biasing voltage.like
resistor,inductor,capacitor are electrical components.
electronic component:
those components which require biasing voltage like:
transistor,diode,IC, thyristor, scr, triac.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
what is transient enclosure vltage , very fast transients, very fast transient over voltages
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
how to find motors H.P. whout any rating? (only give you a motor and multimeter)
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
Give some example of fault limiting devices?
draw 3 phase rectifier diagram
FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
If o/p power is doubled by how much does the sound increase
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
What are the limitations of Kirchoff's laws?
Write down the brushes of a de machine.
Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.
