Interested to Buy Any Domain ? << Click Here >> for more details...
Micro controller input pin voltage is max 5v. If i want
give 50 0r 100v input pin. whether is it possible
- 4 Answers
- 6537 Views
- I also Faced
- E-Mail Answers
Answer Posted / dinesh kumar
if you are try to give that much voltage means ,it does not
accept or it will damage the ic
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
In connections of mcb, is it necessary that the incoming side supply should be connected at top side of mcb. Whether this has any effect in tripping of mcb in case of fault?
What is a varactor diode?
What is graticule?
Tell me why is 400 hz used for flight instruments and radio transmission system in aviation industry universally?
How bjt can be used as an amplifier.
Why emitter is always forward biased?
What is memristor? How many modes it works? Also what is its advantage? How it differ from others & why the name evolve? & What is its uses?
I am studing Diploma Electronics from International Council for Management Studies-CHENNAI. Is it useful for getting engineering job within india or international ?
What are the UE modes in GSM,GPRS,UMTS and LTE
What happens to the series current , load current and zener current when the dc input voltage of a zener regulator increases?
i having one cisco 2950 switch,but i having no rights of ythis switch,now i want to know switch macc addrerss of particular network ip,how can i resolved?
i am preparing for AAI JR EXECUTIVE exams so plz suggest the objective materail for preparation
Define timer.
temperature transmitter range o to 100c over range set value 21.6ma if you give source on the field transmitter showing iop out put also 21.6ma but dcs not showing iop samething if you simulat from hart 21.6ma in dcs showing iop how its possible?
what are the fiber losses,How to rectify it?
