Answer Posted / harish singh

write the program for single push button by using ladder
diagram
Answer
# 9 [----[ ]----------i--------------()---]
[ PB i OP ]
[ i ]
[ i ]
[----[ ]----------i ]
[ OP* ]

typical loop drawing of a simple feedback control comprising of one transmitter and one control

1993

---

KAlman filter code for two dimension?

2068

---

How to Calibrate Ultrasonic flow Transmitter in Field

1269

---

Isometric drawings are generated during _________________ phase of a project

2075

---

A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

2174

---

What is the diffrence between digital signal processing and discrete signal processing?

1983

---

State some of balance principle’ advantages?

1178

---

can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.

2266

---

what is temperature compensation?

5443

---

i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......

2056

---

How to interfacing microcontroller with a DC motor

2058

---

what are the diff. in servo and regulatory control?

3973

---

Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com

2847

---

who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.

5194

---

which type of filter gives the constant phase characteristics?

1926

---