Interested to Buy Any Domain ? << Click Here >> for more details...
In what voltage EHT works(133/132/33/66kv?
- 3 Answers
- 6610 Views
- Adhunik, I also Faced
- E-Mail Answers
Answer Posted / guest
EHT WORK AT 133/132KV
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
How can we calculate ac current from the given DC current when AC voltage is given?
What is the difference between type1 and type2 relay protection co-ordination for motor feeders
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
What is the name of the winding to which supply is given?
Give details of your interested designation, the post you are interested to serve the company better and explain why you think you can serve the company better in such position if employed?
What is referred to the electron in the outer orbit?
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
Why control of DC motor is simpler?
how to calculate the fault in substation
How much of the total hydro power potential has been exploited so far in india?
