Interested to Buy Any Domain ? << Click Here >> for more details...
If you touch power transformer........ Then , in your body
current will flow or not...?
- 7 Answers
- 9572 Views
- I also Faced
- E-Mail Answers
Answer Posted / sudheer
I agree with Mr.Suresh,ecause earth is good conductor as
compared to human body.That's why, even though you touch the
transformer body(dome), it will discharge through the
earthed conductor only.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
the problem faced on star or delta winding connection??
What is phase cross over frequency?
any earth foult trip the relay but in welding time not trip by earth foult
what is per unit calculation?looking for simple and strong explanation thk u
Why 15Amp. MCB is suitable to carry load of 1.5Ton Ac please Explain?
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is the differebt between ac and dc fuse?
The sodium vapor lamp is not glows when it is connected a distance of 5 meters above from gearbox, why ?
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
how to find the resistance and gap volatage of the diode??
