why substation ratings are multiple of 11 means 11\33 kv
substation
Answer Posted / suresh apgenco
For HV lines, insulators used are disc insulators whose each
rating is 11kv. based on the point only we are going to
transmit power in terms of 11kv i.e., 11kv, 22kv,... so on.
hence substation ratings are multiples of 11kv
Is This Answer Correct ? | 6 Yes | 16 No |
Post New Answer View All Answers
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
What is earth?
how to calculate the conductor size for certain KV transmission line and distribution line?
For overhead protection we use which transformer?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
how to get electrical supervisor competency certificate in gujarat. i did 3 year diploma in electrical
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
Efficient electrical earthing in hard rock area
What is the formula to calculate the rating of a three phase air circuit breaker
what is is the potential diffrence between two phase ?
1.main parts of generator? what is used A-check,B-check,C- check? 2.what is FM200 system in data centers? 3.difference between pac,ahu?
HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????
What happen when change order of CT in GIS feeder?
how unidirectional torque is produced in DC motor?