If you touch power transformer........ Then , in your body
current will flow or not...?
- 7 Answers
- 7067 Views
- I also Faced
- E-Mail Answers
Answer Posted / suresh
current wont flow through iur as the transformer bodyis earthed
| Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
On what cycle does thermal power plant operate?
What is installed in PAC that is control the humidity
i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400
What are the material used for inductance coil?
Which do you think is the most significant cause of energy loss in a factory?
Can a generator runs after getting 1st stator earth fault.
Hi everyone, I'm Lachuu, recently joined automation company as PLC Engineer. I have certain basic question, I request all big gurus and seniors to answer these question. Because this will be very helpful to me as well starters like me. How to design a control circuit (ex: pick & place - my current project) Yamaha robot PxYx series controller RCX222, using 6 cylinder double acting, plc keyence kv p16r 2 expansion unit for input and output each. How to select panel terminal mcb elcb powersupply. My main concern in some projects how to select dc power supply, mcb rcb(I came across dif bt b c d curves, but stil confusing, pls help me :-(. I would really appreciate all who are going respond to this question.
How is the connection of the tap changer on the HV side been made?
What is power factor why we should maintain the power factor unless what will happen
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
why is a power transformer used only occasionally?it is used to step up at generating stations?and that needs to be done all day long !!!!!!!
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
What is inverse definite minimum time lag relay? Where is it use?
if field breaker of generator is closed prior to its rated speed on a power generating unit. what will be the effect on generator, unit transformer and starting transformer.
how can we select the type of wire.what factors we have to look on it , do we have some formula to calculate it. please guide me on it
