Interested to Buy Any Domain ? << Click Here >> for more details...
sir plz tell me what is the basic concept of mechanical
maintenance
- 2 Answers
- 8620 Views
- Bhel, HPCL, I also Faced
- E-Mail Answers
Answer Posted / york shipley
the basic concept of mechanical maintenance is to correctly
monitor the operational parameters,inspect the equipment
during the operation to verify the correct functional
performance for which it is intended and if observed any
faults then repair them immediately to maintain safe and
reliable operation of that machine/ device/ equipment.
| Is This Answer Correct ? | 27 Yes | 1 No |
Post New Answer View All Answers
Why large boilers are water tube type ?
explain about where should we use deep groove ball bearings,angular contact ball bearings,spherical roller bearings,taper roller bearings,cylindrical roller bearings and thrust bearings
What do you measure in the banana and mountain diagram?
sir i m final year diploma(mech. engg)student, can i apply for psu,s as like sail, bhel,gail,dmrc.etc..if yes then give me detall about iton my e-mail id meatul90@rediffmail.com...thank you.........
What is meant by hybrid vehicles?
What is the difference between the flight of a plane and a helicopter?
I got i20 for university of bridgeport,university of new heaven and eastern michigan university.Please tell me visa success rate for these universities.And I want to go to Connecticut.At that place two universities are avaliable one is new heaven and the another one is bridgeport.Which is the best? Please give reply as early as possible.
Hello sir I am going to give section engineer examination and will be held in 2010. So I need all prevous years examination papers. please send it on my email id : bhalchandrap@yahoo.co.in
What are the factors that can affect the factor of safety selection?
Can you use motor oil in a hydraulic system?
What is the density of plastic?
What will happened if two gear boxes in parallel are working with different motor speeds?
What is the purpose of turning gear
asked about the power transimmisions and types of power drives and about milling different process types and differnce between straddle milling and gang milling
What is gtsc technology?
