Interested to Buy Any Domain ? << Click Here >> for more details...
Name quantities which are not transformed in the tranformer.
- 3 Answers
- 4866 Views
- I also Faced
- E-Mail Answers
Answer Posted / zeshan faizi
frequency
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What is an Air COmpressor
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
how does an centrifugal and screw type chiller will work. which chiller efficiency is high and why.
HOW THE OLTC TRANSFORMER SAVE ENERGY IN COMPARISON TO OFF LINE TRANSFORMER AND IS IT ECONOMICAL TO REPLACE THE OFF LINE TRANSFORMER TO OLTC TRANSFORMER
how do u gauge the size of the cable ?for eg. consider a 300 sqmm L.T Cable.How do u determine the size of the cable seeing it pratically?
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
what is the use of permanent magnet generator in exciter
how to electronic energy metter failed in electomagnectic fild passing in the metter and which thing to defect more on metter.
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
what is reverse power relay brief explanation and in b/w where it is connected
what is the best transformer oil breakdown voltage?
2- What are the percentages between excitation currents in phase (R, S and T) in ∆ and Ỵ connections in excitation Current test in transformers?
