how system voltage affect the power factor or vice-versa.
Answer Posted / manu
In electrical engineering, particularly power engineering,
voltage regulation is the ability of a system to provide
near constant voltage over a wide range of load
conditions..if increase/decrease of
loadcurrent/powerfactor,-ve or +ve voltage regulation
occur..so system receving end voltage may vary.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is the path of thunderlightening? once both a buffalo and a person were standing 5m apart but lightening hit and killed buffalo not person?
what is the principle of operation of tungstun bulb ??
how can you size an automatic voltage regulator?
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
what should be correct gas pressures to be a 1.5 ac unite
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
Do inductive loads have distorted current waveforms ?
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
what happen if drive input fail momentry at 48.5 HZ frequency?
List the power rating of any 5 important electrical appliances used in houses.
hi....I am from india..i have completed my engineering in electrical and electronics field with 58.4% and my IELTS score is 5.5 bands....Recently i received my I-20 in computer and information science from Troy university in Alabama.On 18th i have a visa interview can u please tell me what type of questions i have to answer ??????
what is the formula of starting current of 3phase and 1 phase motor???
How to distinguish whether MCB is DC or AC looking at it physically