Interested to Buy Any Domain ? << Click Here >> for more details...
Why are there two Ground pins on DIP (Dual In-line Package) of
8086 Microprocessor IC ?
- 3 Answers
- 9575 Views
- Intel, Reliance, I also Faced
- E-Mail Answers
Answer Posted / monk
pin no 1 & 20 are the ground pin and both pin perform the
same task.
2 pin are there in 8086 just to make the count of total pin
40 so that it can fit in the ic package
| Is This Answer Correct ? | 8 Yes | 7 No |
Post New Answer View All Answers
im ece student.im applyng 4 rrb junior engineer (electrical) i got hallticket....plz...try to send the syllabus of junior engineer(electrical)
Serial to parallel conversion is done by ?
Tell me why bjt is called current control device?
steps which are performed in the bios POST codes
I am stuck up with a question on appending of two arrays
I am writing the code for the same, I am appending two
strings this way
int main()
{
string s1 = "Welcome to C++";
string s2 = "C++ improves the logic ability";
string s3 = s1 + s2;
cout< What ODU work? How many types of Transmission cards are in Ultra BTS? draw the circuit diagram of a transistor frequency
convertor using a tetrode transistor? Explain the difference between a multiplexer and encoder? Define why series inductor and l-section filters cannot be used with half-wave rectifiers? If we use heat sinkble rechem make HT jointing kit for XLPE
HT (6KV)termination at HT side of transformenr, Is it
required to fill the HT termination with Epoxy compoud? Why is bleeder resistance employed in a filter circuit? List out the direct type adcs. Why fet is known as voltage control device? What is the difference between active and passive filters?
