Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rajesh tewari
current in primary
=kva*1000/1.732*primary voltage
current in secondary
=kva*1000/1.732*secondary voltage
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
how slip power recovery system work
What is meant by rotor?
what is diff. between earthing grid,earthing mess, earting grid?
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
DEAR SIR,I GOT THE CALL LETTER FROM RRB, SECUNDERABD AS A JE-II SO PLEASE PROVIDE ME SOME MODEL QUESTION AND ANSWER PAPERS AND LAST YEAR QUESTION PAPERS
What is the difference between Delta & Wye windings?
how to fit 3 HP crompton gear motor with conveyor with the use of staring delta starter or ordinary starter?
what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.
what material is the electrical housing wire made of? is there any difference for the telephone lines?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
Any one can explaination about calibration with rotating sub standards?
