Interested to Buy Any Domain ? << Click Here >> for more details...
Why electrical engineer use Cu Strip for transformer
neutral why not GI Strip? What if we use GI instead of Cu
does it affects the transformer performance.
- 7 Answers
- 18260 Views
- I also Faced
- E-Mail Answers
Answer Posted / mallikarjuna reddy
Electrical peoples widely used cu strips instead of GI
strips for transformer neutral,because whenever unbalance
currents occurs in the line it have to flow to the
ground,for this we need high conductivity material.thats
why we are using cu. strip instead of GI strip.usually
copper is an high conductivity material than GI material
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Explain the working of variable frequency transformer?
PLZ EXPLAIN THE INTERLOCKING AND CONTROLLING OF CONTACTORS????HOW CAN I DO THAT?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
plz tell me,ht and lt panel terminals in substations explain beiefly
what is meant by power and distribution transformer ?
Why is tan-delta test and capacitor measurement done on alternator?
Why two phase welding machine is used instead of three phase welding machine.
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
What is different between Difnit time and instatous over current relay
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
what is earth pit , how we can measured it, what earth rods reference
Why does the radius of armature is less than the radius of pole shoe?
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
i am venkat i got gre 930(verbal 270 quanta 660) and my toefl score 105..here question is why u got less score in gre ? what i supposed to tell...any chance of rejection is there...my accadamics record is very good
