Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mallikarjuna reddy
usually fan having two types of windings,i.e starting wdg &
Running wdg.
whenever we switch on the supply the fan may take the
moment slowly due to starting wdg,at this time fan requires
some reactive power(because fan wdg acts as inductive
load),at this time capacitor supplies this reactive
power.then only the fan will rotates with its own RPM.
| Is This Answer Correct ? | 12 Yes | 22 No |
Post New Answer View All Answers
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
what is the difference between switch yard to residential area.and how much required it.
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
I want to replace the 3 KW DC motor with AC motor so what should be the rating of AC motor? Details Of DC motor to be changed with AC are - Kw - 3, Vf - 310, If - 0.15, Va - 400, Ia - 13, RPM - 2400
DG SET BLOCK DIGRAM
How many size of cable required for a 300m long and 30kw inductive lode
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
Why PS class CT is always preferred for Differential protection?
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
how many parameters can integrate with fire alarm basically ?
why transformer tank is in rectangular shape what happen when it is in step shape
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
how the characterstics of control valve being done
300m long and 30kw inductive loade 3phase supply how many size cable required
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
