Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sambi reddy
HART & BRAIN both are nothing but calibraters.
rose mount make used HART protocol.
yokogawa make used BRAIN to calibrate transmitters.
| Is This Answer Correct ? | 9 Yes | 35 No |
Post New Answer View All Answers
Draw symbols of the following :
sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com
how we are selecting instuments by differentiating certain instruments in 4 to 20 ma range and certain in 1 to 5 v dc
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
Describe how to use megger to measure the earth resistance and insulation resistance
What is rang ability?
why we take %i0.0 as input for twido plc
Specific gravity.
what is the difference between Cv and air consumption? why the customer needs Air consumption details?
I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.
what are procedure of sox-nox calibration
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What is difference between differential pressure & delta pressure?
