Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / thiyaarajan
While meaasuring PV it if goes below or above set point
alarm will be generated. Then if PV reaches set point the
alarm will reset. but if the PV fluctuates then to avoid
frequent alarm we have to give some % for the alarm to
reset. That % is called as Deab band value.
| Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
give me all the details about the interview and which type of question being asked
which type of zones used for boiler? & why ?
What is the difference between working pressure and calibration pressure of a control valve
Give Detail information about plc,dcs,and scada system?
what is piezoelectric transducer?give an example in power plant n state its principle?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
Name different types of bourdon tubes.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Programmable Logic control.
State bernoulli’s application.
can you send remote seal interface level transmitter calculation steps for oil water saperator.
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
Explain the working principle of lvdt?
In which principles tx ,pressure gauge,Temp gauge,control valve works?
In apron feeder how TPH is calculated?
